Rigid Rear Fender Assembled
You will also need another part
Description
Rigid rear fender features relief over skirts to accept stainless fender trim attached by clips. Fender is 7-1/2" wide with 3/4" wide brackets. It is fully assembled and riveted together with hinge and is drilled for the U-clamps. Fender is not equipped with a tail lamp hole. Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket. All hinged fenders must be hand fitted at hinge and pin area prior to primer or paint. Alignment will have to be adjusted and tweaked to fit your components. Fender tail is not drilled or cut out for tail lamp installation.
*NOTE: Optimal updated hinge is availble for restorers who would like to replace hinge on our fenders. We suggest pre-fitting fender prior to painting.
*NOTE: Chain panel on left side is part of fender, non-removeable. The body and skirt are one piece!
*Note: UPS may consider this part as packaged "oversize" for shipment, as compared to the actual weight, which will result in higher shipping costs.
Specifications
- V-Twin number
- 50-0143
- OEM number
- 59604-39
- Manufacturer
- Wyatt Gatling
- Sold as
- 1 - EA
- Origin
- Imported
- Measurements
- Fender Width: 7-1/4"
- Style
- Stock
- 2026 catalogue pages
- 627
Goes with this part
V-Twin lists these alongside 50-0143 — replacements, the parts commonly fitted at the same time, and supersessions. Check the fitment on each before ordering.