Factory Sample Rigid Rear Fender Assembled
You will also need another part
Description
Factory sample rigid rear fender features relief over skirts to accept fender trim attached by clips. This is fully assembled, riveted together with hinge and is drilled for U-clamps. This is not equipped with a tail lamp hole. Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket, and must be hand fitted at hinge and pin area. Alignment will have to be adjusted and tweaked to fit your components. Fender tail is not drilled or cut-out for tail lamp installation.
*NOTE: Optimal updated hinge is available for restorers who would like to replace hinge on our fenders. We suggest pre-fitting fender prioer to painting.
*NOTE: Chain panel on left side is part of the fender, non-removeable. The body and skirt are one piece! Factory sample is a brand new pre-production parts but may have imperfections on the finished surface. Check threaded and bearing holes for excess plating before installation. There are no physical defects, such as cracks or holes, there will be cosmetic imperfections only. Sample parts may show marks from installation test and fitment.
*NOTE: UPS may consider this part as packaged "oversize" for shipment, as compared to the actual weight, which will resul
Specifications
- V-Twin number
- 50-2241
- OEM number
- 59604-39
- Manufacturer
- V-Twin
- Sold as
- 1 - EA
- Origin
- Imported
- Measurements
- Fender Width: 7-1/4"
- Style
- Stock