1949-54 FL Rigid Rear Fender
Before you order — V-Twin tech note
- Underside of rigid rear fender details: A) Wire Loom Spring,B) Hinge Junction, C) Loom Clip Strip on Fender Radius, D) Spring Clip, E) 7/8" Wide Brace, F) Ribbed Chain Panel.
- *NOTE: Replacement fender ordered thru H-D dealer came with 3/4" brackets. These were over the counter replacements, notOEM installed at the factory.
- Suggested to use with #31-0186, Parkerized Rear Kickstand Catch
- Suggested to use with #50-1250, Wire loom Fender Strip Raw
Description
2024 New Production rear rigid fender assembly includes a segmented wire loom conduit and features an updated hinge design for the rear tail. Chain panel is ribbed and part of the fender. Assembly features a raw finish. Rigid rear fender features a three rib indent in the chain guard cut-out panel and 7/8" wide braces. 1949 rigid rear fender features a one rib indent. Wire loom provisions on underside includes replica rigid rear fender hinge, spring connector loom, and segmented tube on skirt. Assembly is for use with Tombstone tail lamps. Includes straps and u starp reveted in place.
*NOTE: Does not accept stainless steel fender trim and clips for this year.
*NOTE: Replacement fenders ordered through H-D dealers came with 3/4" brackets that are "over the counter" replacements, not OEM installed by the factory. Constructed with 3/4" fender brace.
*NOTE: Fender tail with cut out is #50-0366.
Specifications
- V-Twin number
- 50-0429
- Manufacturer
- V-Twin
- Sold as
- 1 - KIT
- Origin
- Imported
- Measurements
- Strap Brace Width: 7/8"
- 2026 catalogue pages
- 631
Goes with this part
V-Twin lists these alongside 50-0429 — replacements, the parts commonly fitted at the same time, and supersessions. Check the fitment on each before ordering.